User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Configuring Network Settings
Chapter 6: Managing Your Network 155
The Edit Network Settings page for the LAN network appears.
3. In the Mode drop-down list, select Enabled.
The fields are enabled.
4. If desired, change your Safe@Office appliance’s internal IP address.
See Changing IP Addresses on page 156.
5. If desired, enable or disable Hide NAT.
See Enabling/Disabling Hide NAT on p
age 157.
6. If desired, configure a DHCP server.
See Configuring a DHCP Serve
r on page 158.
7. Click Apply.
A warning message
appear
s.
8. Click OK.
A success message appears.