User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Setting Up Dialup Modems
Chapter 5: Configuring the Internet Connection 141
Setting Up a USB Modem
Warning: Before attaching a USB modem, ensure that the total power drawn by all
connected USB devices does not exceed 2.5W per port (0.5A at 5V). If the total
current consumed by a port exceeds 0.5A, a powered USB hub must be used, to
avoid damage to the gateway.
To set up a USB modem
1. Connect a USB-based modem to one of your Safe@Office appliance's USB
ports.
For information on locating the USB ports, see Introduction on page 1.
2. Click Networ
k in the main menu, and click the Ports ta
b.
The Ports page appears.