User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Setting Up Dialup Modems
Chapter 5: Configuring the Internet Connection 137
Setting Up an RS232 Modem
Note: Your RS232 dialup modem and your Safe@Office appliance's Serial port must
be configured for the same speed.
By default, the appliance's Serial port's speed is 57600 bps. For information on
changing the Serial port's speed, refer to the Embedded NGX CLI Reference
Guide.
To set up an RS232 dialup modem
1. Connect an RS232 dialup modem to your Safe@Office appliance's serial port.
For information on locating the serial port, see Introduction on page 1.
2. Click Networ
k in the main menu, and click the Ports ta
b.
The Ports page appears.