User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Using Internet Setup
134 Check Point Safe@Office User Guide
In this field… Do this…
Dead Connection
Detection
Probe Next Hop Select this option to automatically detect loss of connectivity to the default
gateway. If you selected LAN, this is done by sending ARP requests to the
default gateway. If you selected PPTP, PPPoE, or Dialup, this is done by
sending PPP echo reply (LCP) messages to the PPP peer.
By default, if the default gateway does not respond, the Internet
connection is considered to be down.
If it is determined that the Internet connection is down, and two Internet
connections are defined, a failover will be performed to the second
Internet connection, ensuring continuous Internet connectivity.
This option is selected by default.