User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Using Internet Setup
132 Check Point Safe@Office User Guide
In this field… Do this…
Advanced
External IP If you selected PPTP, type the IP address of the PPTP client as given by
your ISP.
If you selected PPPoE, this field is optional, and you do not have to fill it
in unless your ISP has instructed you to do so.
MTU This field allows you to control the maximum transmission unit size.
As a general recommendation you should leave this field empty. If
however you wish to modify the default MTU, it is recommended that you
consult with your ISP first and use MTU values between 1300 and 1500.
MAC Cloning A MAC address is a 12-digit identifier assigned to every network device. If
your ISP restricts connections to specific, recognized MAC addresses, you
must select this option to clone a MAC address.
Note: When configuring MAC cloning for the secondary Internet
connection, the DMZ/WAN2 port must be configured as WAN2; otherwise
this field is disabled. For information on configuring ports, see Managing
Ports on page 205.
Hard
w
are MAC
Address
This field displays the Safe@Office appliance's MAC address.
This field is read-only.
Cloned MAC
Address
Do one of the following:
• Click This Computer to automatically "clone" the MAC address of
your computer to the Safe@Office appliance.
• If the ISP requires authentication using the MAC address of a
different computer, type the MAC address in this field.
Note: In the secondary Internet connection, this field is enabled only if the
DMZ/WAN2 port is set to WAN2.