User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Using Internet Setup
Chapter 5: Configuring the Internet Connection 125
Configuring a Dialup Connection
Note: To use this connection type, you must first set up the dialup modem. For
information, see Setting Up Modems on page 136.
1. In the Port drop-down list, do one of the following:
• To configure a Dialup connection on the Serial port (using a connected RS232
modem), select Serial.
• To configure a Dialup connection on a USB port (using a connected USB
modem), select USBModem1.
The Connection Type field displays Dialup.
2. Complete the fields using the relevant information in Internet Setup Fields on
page 127.