User Manual Part 1
Table Of Contents
- Check Point Safe@Office User Guide 8.0
- Copyright & Trademarks
- Contents
- About This Guide
- Introduction
- About Your Check Point Safe@Office Appliance
- Safe@Office 500 Product Family
- Product Features
- Wireless Features
- Optional Security Services
- Software Requirements
- Getting to Know Your Safe@Office 500 Appliance
- Getting to Know Your Safe@Office 500W Appliance
- Getting to Know Your Safe@Office 500 ADSL Appliance
- Getting to Know Your Safe@Office 500W ADSL Appliance
- Contacting Technical Support
- Safe@Office Security
- Installing and Setting Up Safe@Office
- Getting Started
- Configuring the Internet Connection
- Managing Your Network
- Using Bridges
- Configuring High Availability
- Using Traffic Shaper
- Working with Wireless Networks
- Viewing Reports
- Viewing Logs
- Setting Your Security Policy
Overview
Chapter 5: Configuring the Internet Connection 85
Chapter 5
This chapter describes how to configure and work with a Safe@Office Internet connection.
This chapter includes the following topics:
Overview....................................................................................................85
Using the Intern
et Wizard ..........................................................................86
Using Internet Setup.................................................................................102
Setting Up Dialup Modems......................................................................136
Viewing Internet Connection Inform
ation
................................................145
Enabling/Disabling the In
ternet Connection.............................................148
Using Quick Internet Connection/Disconnec
tion.....................................149
Configuring a Backup Interne
t Connection..............................................149
Configuring WAN Load Balancing..........................................................15
0
Overview
In order to access the Internet through your Safe@Office appliance, you must configure
one of the following connection types:
• Ethernet-based connection
You can configure an Ethernet-based connection in all models. An Ethernet-based
connection can be connected to another network by means of a switch, a router, a
bridge, or an Ethernet-enabled broadband modem.
In ADSL models, the Ethernet-based connection is configured on the DMZ/WAN2
port. In non-ADSL models, you can use the WAN port, the DMZ/WAN2 port, or both
ports for an Ethernet-based Internet connection.
• Direct ADSL connection
You can configure a direct ADSL connection in Safe@Office ADSL models only.
These models include an integrated ADSL modem, which enables you to connect the
appliance directly to your ADSL line without using an additional modem or router.
Configuring the Internet Connection