User's Manual
802.11g/super-g WLAN Card User’s Manual
- 30 -
Appendix A Setting Up TCP/IP
This section contains instructions for configuring the TCP/IP protocol of the
Wireless LAN Card. The IP address policy depends on your network. You
should configure your TCP/IP protocol as instructed by your network
administrator.
For Windows 2000/XP
1. Double-click Network Dial-up Connections (Windows 2000) or Network
Connections (Windows XP) on Control Panel.
2. Right-click the Local Area Connection icon corresponding to your
wireless adapter and click Properties.
3. On the General tab, highlight Internet Protocol (TCP/IP) and then click
Properties.
Option A: Use fixed IP address.
Enable the Use the following IP Address option. Enter the IP address,
Subnet Mask and Default gateway. Then click OK.
Option B: Use dynamic IP address
Select Obtain an IP address automatically.
4. Close the Local Area Connection Properties window. For Windows
2000, if prompted, click Yes to restart your computer.