Quick Start Guide

1. Place the GENESIS

™

Sparkling Water Maker on a ﬂat sturdy surface in an upright

position. Remove the carbonating bottle if it is installed in the Sparkling Water

Maker. Never insert or replace the cylinder while a carbonation bottle is installed

in the Sparkling Water Maker. Press the button located at the rear to release the

Sparkling Water Maker's head from the body.

2. Pull the Sparkling Water Maker's head upwards and remove it. Set it to one side.

3. Remove seal and cap from the SodaStream CO

cylinder. Insert the cylinder into the

cylinder holder in the Sparkling Water Maker's head and screw to the right while

applying gentle pressure until it is ﬁrmly held in place. Hand-tighten only; DO NOT

use tools.

4. Place the Sparkling Water Maker’s head onto the Sparkling Water Maker. Push

down until you hear a click. Now you are ready to create the bubbles.

INSTALLING THE CO

CYLINDER INSTALLING THE CO

CYLINDER