User Guide

SET UP
INSTALLING THE CO
2
CYLINDER
SODASTREAM CO
2
SCREW SYSTEM CYLINDER
1. Place the SodaStream
®
Genesis
TM
Sparkling Water Maker
on a flat sturdy surface.
2. Remove seal and cap from the SodaStream CO
2
Cylinder.
WARNING! Never insert or replace the CO
2
Cylinder while a
Plastic Carbonating Bottle is installed in the Sparkling
Water Maker. This can cause the Plastic Carbonating
Bottle to be ejected or burst.
3. Press the button located at the rear to release the
Sparkling Water Maker's head from the body. Pull the
Sparkling Water Maker's head upwards and remove it. Set it to
one side.
4. Insert the CO
2
Cylinder into the cylinder holder in the Sparkling
Water Maker's head and screw to the right while applying
gentle pressure until it is firmly held in place. WARNING!
Hand-tighten only. DO NOT use tools, this can damage the
Sparkling Water Maker or CO
2
Cylinder, which may result
in an uncontrolled flow of CO
2
gas, causing the
Carbonating Bottle to burst.
5. Place the Sparkling Water Maker’s head onto the Sparkling
Water Maker. Push down until you hear a click. Now you are
ready to create the bubbles.
Please note that the
SodaStream
®
Genesis
TM
is
compatible with the
SodaStream CO
2
Screw
System Cylinder and is NOT
compatible with the
SodaStream Quick Connect
Cylinder.
1
5
COMPATIBLE SODASTREAM
CO
2
QUICK CONNECT CYLINDER
NON-COMPATIBLE
CO
2
SCREW SYSTEM CYLINDER
Use Only SodaStream
CO
2
Screw System Cylinder
1
2
3
4