User Instructions

40 EN
DIRIS Digiware M-50 & M-70 - 548751C - SOCOMEC
14. DIRIS DIGIWARE M-50/M-70 TECHNICAL
CHARACTERISTICS
14.1. Mechanical characteristics
Weight DIRIS Digiware M-50 / M-70 210 g
14.2. Communication characteristics
Default Ethernet settings - IP address: 192.168.0.4
- Mask: 255.255.255.0
- Gateway: 192.168.0.1
Maximum slave devices 32
Ethernet RJ45 10/100 Mbs Gateway function:
- MODBUS TCP / RTU
- BACNET IP
- SNMP v1, v2 & v3
Embedded software Web-Config (M-50/M-70) for configuration of M-50/M-70.
WEBVIEW-M (M-70 only) for visualization of measurement data.
SNTP Updates the M-50/M-70 from an SNTP server.
The M-50/M-70 updates the connected devices.
SMTP(S) Sends email notifications in case of an alarm on a downstream device.
FTP(S) Automatically exports data to an FTP server (standard or secure FTP):
Energies Index, load curves (Powers), Trends (measurement logs).
RJ45
Digiware Control and power supply interface function.
RS485 2-3 wires 1 port, configured as Input (Master) or Output (slave).
Speed 9600 bds (10 devices max).
38400 bds - 115200 bds (32 devices max).
Micro USB For configuration via EasyConfig System software or firmware upgrade via Product
Upgrade Tool.
RJ9 Not used.
Bluetooth Low Energy
Use: feature not implemented yet.
Operating frequency: 2402 to 2480 MHz.
EIRP Power for CE, Australia/New Zealand : 6.23 dBm (measured max. average)
Max Power for FCC/IC : 3.15 dBm .
14.3. Wireless Characteristics
14.3.1. Canada
This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with greater than 20cm between the radiator & your body. Le présent appareil est
conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter
tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
Déclaration d’exposition aux radiations:
Cet équipement est conforme aux limites d’exposition aux rayonnements ISED établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé à plus de 20 cm entre le radiateur et votre corps.