Manualshelf

Users Manual Part 1

ManualsBrandsSOCOMEC ManualsElectronicsMultipoint Display
21222324252627282930
26 EN
DIRIS Digiware D-50 & D-70 - 548088C - SOCOMEC
You can nd the IDs on the marking on the products (546434 on the U-30 and F0C1D2 on one of the I-30s) as shown in
the picture below:
You can now perform the conguration of the system. Each product must be congured individually.
8.3. Conguring the DIRIS Digiware system from the D-50/D-70 display
Go to "Parameters" > "Congure a device".
PARAMETERS
|
LOAD1
DISPLAY
CONFIGURE A DEVICE
AUTODETECT SERIAL DEVICES
LIST PRODUCTS
ADD NEW DEVICE
…
There are 2 steps to congure the DIRIS Digiware system:
• Network: setting the type of voltage network: single-phase (1P+N), two-phase (2P), three-phase without neutral (3P),
three-phase with neutral (3P+N).
• Load: conguring the loads/circuits measured. You can, for example, measure three-phase and single-phase loads
connected to a three-phase electrical network.