Owners manual

Automatic Reconnections

Each time you power on the CHS, it will automatically try to connect

to the last device it was connected to.

• Make sure the device is in range with Bluetooth On.

• If using HID mode, pressing the trigger button will force or trigger

the connection.

• If using Advance (iOS) mode, make sure the Scanner-enabled

Application is active.

• If using SPP mode, make sure SocketScan 10 software or an

application developed with SocketScan 10 SDK is running.

Make sure the device is on and in range. While the CHS is attempting

to connect the Blue LED will blink every second.

• If a connection is made, the Blue LED will blink every 3 seconds.

• If a connection is not made after 30 attempts, the CHS will emit a

long beep.

BLUETOOTH CONNECTION