User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Setup for Windows Mobile
- STEP 1: Uninstall Other Scanning Software
- STEP 2: Install the Software
- STEP 3: Insert the CF RFID Reader-Scan Card
- STEP 4: Assign Trigger Button(s)
- STEP 5: Read Data into a Windows Program
- OPTIONAL: Configure RFID
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sounds
- OPTIONAL: Configure Bar Code Symbologies
- OPTIONAL: Use SocketScan Trigger
- OPTIONAL: View Version Information
- 3 | RFID Demo
- Appendix A Product Specifications
- Appendix B HF RFID Standards and Tag Descriptions
- Appendix C Bar Code Label Specifications
- Appendix D Class 1 vs. Class 2 Laser Scanners
- Appendix E Enabling or Disabling Symbologies
- Appendix F Laser Decode Zone
- Appendix G Troubleshooting
- Appendix H Technical Support
- Limited Warranty
- Regulatory Compliance
3 | RFID Demo
This chapter shows how to use the Socket RFID Demo
application with the Socket CF RFID Reader-Scan Card to
perform the following:
• Read an RFID Tag.
• Enable Loop Mode.
• Select Tag Type.
• Advanced – Write to Tag.
Before you begin using the Socket RFID Demo application, make sure you
have done the following:
• Installed the RFID Demo application onto your Pocket PC, following
the same software installation procedure described in Chapter 2.
• Inserted the CF RFID Reader-Scan Card into your Pocket PC.
• When you use this application, you should only trigger the RFID Reader
Card by tapping on the Select Tags or Read Tag button on the RFID
Demo screen.
26