User's Manual
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Setup for Windows Mobile
- STEP 1: Uninstall Other Scanning Software
- STEP 2: Install the Software
- STEP 3: Insert the CF RFID Reader-Scan Card
- STEP 4: Assign Trigger Button(s)
- STEP 5: Read Data into a Windows Program
- OPTIONAL: Configure RFID
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sounds
- OPTIONAL: Configure Bar Code Symbologies
- OPTIONAL: Use SocketScan Trigger
- OPTIONAL: View Version Information
- 3 | RFID Demo
- Appendix A Product Specifications
- Appendix B HF RFID Standards and Tag Descriptions
- Appendix C Bar Code Label Specifications
- Appendix D Class 1 vs. Class 2 Laser Scanners
- Appendix E Enabling or Disabling Symbologies
- Appendix F Laser Decode Zone
- Appendix G Troubleshooting
- Appendix H Technical Support
- Limited Warranty
- Regulatory Compliance
OPTIONAL: View Version Information
SocketScan includes an About screen which displays the SocketScan
version, as well as the firmware/scan engine version for the selected device.
1. In the Today screen, check the SocketScan icon at the bottom of the
screen to verify that the correct device is selected. If required, select the
correct device by tapping on the icon and in the pop-up menu, selecting
the device you want.
2. Tap on the SocketScan icon at the bottom of the screen. In the pop-up
menu, tap About. The screen reports the SocketScan version.
If the RFID Reader is currently selected, the RFID firmware version
will also appear.
If the bar code scanner is currently selected, the scanning
engine/firmware version will appear.
Note: If you need technical support for your device, please include these
firmware versions with your request.
CHAPTER 2: SETUP FOR WINDOWS MOBILE 25