User's Manual
Table Of Contents
- P500CF Users Guide 2.pdf
- Copyright Notice
- 1 | Introduction
- 2 | Software Installation
- 3 | Open or WEP-Enabled Networks
- 4 | WPA or 802.1x Networks
- 5 | Wi-Fi Companion
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Network Information
- Appendix D Troubleshooting
- Appendix E Technical Support
- Limited Warranty
- Limited Software Warranty
- Regulatory Compliance for Go Wi-Fi!
2 | Software Installation
Follow these instructions to install the software into your Pocket PC.
• If you are using Wi-Fi Companion with the built-in WLAN radio of
your Pocket PC, you will need to register the software after you install it
to activate a full version of the software.
• If you are using Socket Go Wi-Fi!, you will need to install two software
components: the card drivers and Wi-Fi Companion. No software
registration is required to use the software with Go Wi-Fi!
A
DVANCED USERS: For CAB file installation instructions, please refer to
the README file in the installation CD.
.
Software Installation
1. Go Wi-Fi!: If your Pocket PC already has an older version of Socket
WLAN software, you must completely remove it before you install the
new software. Remove both the utility and the card drivers.
• Make sure the WLAN card is not in the Pocket PC.
• Tap Start | Settings | System tab | Remove Programs.
• Select the WLAN card drivers and tap Remove.
• Repeat to remove the WLAN utiity.
• Soft reset the Pocket PC by pressing the reset button.
2. Make sure you have ActiveSync 4.0 or greater. Download it free online:
msdn.microsoft.com/mobility/windowsmobile/downloads/default.aspx
3. Make an active connection between your Pocket PC and a host PC. Use
ActiveSync and a serial/USB connection cable or cradle.
8