User Guide

AUTO MODE (CHARGING STAND)
If you have purchased the Socket Mobile Charging Stand, the
S740 can both charge and scan stationary in Auto Mode.
1. Pair and connect the S740 to your device prior to placing the
scanner in Auto Mode.
2. Scan Auto Mode Barcode.
3. To avoid excessive power drain, the scanner should not be left
out of the Stand in Auto Mode. Either press the Scan button or
Power off the scanner.
Auto Mode (In the Stand)
Action Behavior
Notication
Beep Pattern Light Activity Vibrate
Place Scanner
in the Stand
Scanner
switches to
Auto Mode
High-high tone
conrms proper
seating*
Battery Status
Light is Dis-
abled
None
Place a barcode
in the Scanners
Field of View
Read Bar Code 1 Beep when
Data success-
fully scanned
Green Light
blinks (while
scanning)
None
Mobile Mode (Not in the Stand)
Action Behavior
Notication
Beep Pattern Light Activity Vibrate
Remove the
Scanner from
the Stand and
press the Scan
button
Scanner
switches to
Mobile Mode
None Battery Status
Light is Enabled
Enabled
Press the Scan
button
Decode Bar
Code
1 Beep when
Data success-
fully scanned
Green Light
blinks (while
scanning)
Vibrate when
Data success-
fully scanned
21