- Ethernet Blaster Communications Cable User Guide

3–6 Altera Corporation
EthernetBlaster Communications Cable User Guide December 2004
Revision History
■ Refer to the following procedures in Quartus II Help:
● Programming a Single Device or Multiple Devices in JTAG or
Passive Serial Mode
● Programming a Single Device in Active Serial Programming
Mode
● Selecting the Communications Cable for the SignalTap II Logic
Analyzer
■ Refer to the following introduction and overview topics in
Quartus
®
II Help:
● Programmer Introduction
● Overview: Working with Chain Description Files
● Overview: Converting Programming Files
Revision History
The table below shows the revision history of this user guide.
How to Contact
Altera
For the most up-to-date information about Altera products, go to the
Altera world-wide web site at www.altera.com. For technical support on
this product, go to www.altera.com/mysupport. For additional
information about Altera products, consult the sources shown below.
Chapter Date Version Changes Made
All December 2004 1.0 Initial release
Information Type USA & Canada All Other Locations
Technical support www.altera.com/mysupport/ www.altera.com/mysupport/
(800) 800-EPLD (3753)
(7:00 a.m. to 5:00 p.m. Pacific Time)
[phone] (1)
(7:00 a.m. to 5:00 p.m. Pacific Time)
Product literature www.altera.com www.altera.com
Altera literature services [e-mail] (1) [e-mail] (1)
Non-technical customer
service
[phone]
(7:00 a.m. to 5:00 p.m. Pacific Time)
[phone]
(7:00 a.m. to 5:00 p.m. Pacific Time)
FTP site ftp.altera.com ftp.altera.com
Note:
(1) You can also contact your local Altera sales office or sales representative.