- Ethernet Blaster Communications Cable User Guide

Altera Corporation 3–5
December 2004 EthernetBlaster Communications Cable User Guide
EthernetBlaster Communications Cable User Guide
References
For more information on configuration and in-system programmability
(ISP), see the following sources:
■ AN 39: IEEE 1149.1 (JTAG) Boundary-Scan Testing in Altera Devices
■ AN 95: In-System Programmability in MAX Devices
■ “Configuring Cyclone FPGAs” chapter in the Cyclone Device
Handbook
■ “Configuring Cyclone II Devices” chapter in the Cyclone II Device
Handbook
■ “Configuring Stratix II Devices” chapter in Volume 2 of the Stratix II
Device Handbook
■ “Configuring Stratix and Stratix GX Devices” chapter in the Stratix
Device Handbook
■ “In-System Programmability Guidelines for MAX II Devices”
chapter in the MAX II Device Handbook
■ Serial Configuration Devices Data Sheet
■ “Programming & Configuration” chapter in the Introduction to
Quartus II manual
■ The Programming module of the Quartus II online tutorial
■ Refer to the following glossary definitions in Quartus II Help:
● “EthernetBlaster Cable” (general description)
● “Configuration scheme” (general description)
● “Programming files” (general description)
Table 3–5. EthernetBlaster Cable DC Operating Conditions
Symbol Parameter Conditions Min Max Unit
V
IH
High-level input voltage V
CC(TARGET)
< or = 3.3 V
V
CC(TARGET)
–0.2 V
High-level input voltage V
CC(TARGET)
> 3.3 V
3.1 V
V
IL
Low-level input voltage
0.15 V
V
OH
5.0-V high-level output voltage V
CC(TARGET)
= 4.5 V, I
OH
=20µA
3.3 V
3.3-V high-level output voltage V
CC(TARGET)
= 3.0 V, I
OH
=20µA
2.0 V
2.5-V high-level output voltage V
CC(TARGET)
= 2.375 V, I
OH
=20µA
1.6 V
1.8-V high-level output voltage V
CC(TARGET)
= 1.71 V, I
OH
=20µA
1.15 V
1.5-V high-level output voltage V
CC(TARGET)
= 1.43 V, I
OH
=20µA
0.95 V
V
OL
5.0-V low-level output voltage V
CC(TARGET)
= 5.5 V, I
OL
=1mA
0.4 V
3.3-V low-level output voltage V
CC(TARGET)
= 3.6 V, I
OL
=1mA
0.4 V
2.5-V low-level output voltage V
CC(TARGET)
= 2.625 V, I
OL
=1mA
0.4 V
1.8-V low-level output voltage V
CC(TARGET)
= 1.89 V, I
OL
=1mA
0.4 V
1.5-V low-level output voltage V
CC(TARGET)
= 1.57 V, I
OL
=1 mA
0.4 V
I
CC(SYS)
Operating current (No Load) Typical I
CC(SYS)
= 350mA @ V
CC(SYS)
= 12V
700 mA