- Ethernet Blaster Communications Cable User Guide

2–4 Altera Corporation

EthernetBlaster Communications Cable User Guide December 2004

Resetting the Hardware

The EthernetBlaster communications cable restarts. When the status

LED emits a steady green light, the EthernetBlaster has successfully

reset and the new password is effective.

Resetting the

Hardware

The EthernetBlaster communications cable reset button is located on the

Ethernet port side of the hardware. See Figure 2–3.

Figure 2–3. Machine Reset button

Use a small pointed object such as a paper clip to press the machine reset

button to restart and reset all values to the default factory settings. See

Table 2–1 for a list of factory default settings.

Table 2–1. Default Factory Settings

Setting Value

Connection Type DHCP

Host name acebXXXX (1)

Domain name Clear

Timeserver Name/IP Clear

IP Address 192.168.0.50

Subnet Mask 255.255.255.0

Default Router 192.168.0.1

DNS Server 1 0.0.0.0

DNS Server 2 0.0.0.0

Administrative Password password

Quartus II Remote Connection Password password

Note:

(1) The host name and MAC address are located on the label on the base of

your cable. The last 4 digits of the MAC address represent the “XXXX” in the

host name.

ETHERNET

DC12V

Machine Reset Paper cli