- Ethernet Blaster Communications Cable User Guide

2–2 Altera Corporation
EthernetBlaster Communications Cable User Guide December 2004
Managing Passwords
1 When you change the Quartus II remote connection password,
client systems using the EthernetBlaster communications cable
must remove the hardware from their Quartus II Programmer
hardware setup. See Chapter 1, “Removing the EthernetBlaster
Hardware from the Quartus II Software Programmer Hardware
Setup” for details. The hardware then needs to be added back
into the Quartus II software. See Chapter 1, “Setting Up the
EthernetBlaster Hardware in the Quartus II Software” for
details.
Changing the Administrative Password
To change the administrative password, follow the directions below:
1. Open and log into the EthernetBlaster administrative web page in
your browser.
1 See Chapter 1, “Setup,” for instructions on accessing the
administrative web page using your specific connection.
2. Click the Change Admin Password tab. See Figure 2–1 below.
Figure 2–1. Change Admin Password Page
3. Enter the new administrative password in the New Password field
and again in the Confirm New Password field. Click Apply.