- Ethernet Blaster Communications Cable User Guide

Altera Corporation 1–13
December 2004 EthernetBlaster Communications Cable User Guide
About the EthernetBlaster Communications Cable
2. Click the Change Settings tab and select DHCP from the
Connection Type menu. See Figure 1–8 below.
Figure 1–9. EthernetBlaster Change Settings Page
1 Contact your network administrator if you do not know the
settings to complete the Change Settings page.
3. Click Apply. The EthernetBlaster communications cable
automatically restarts. When the status LED returns to a steady
green state, the EthernetBlaster communications cable has
successfully restarted and can now be added to the Quartus II
software. See “Setting Up the EthernetBlaster Hardware in the
Quartus II Software” on page 1–13.
Setting Up the EthernetBlaster Hardware in the Quartus II
Software
Use the following steps to set up the EthernetBlaster communications
cable in the Quartus II software.
1. Start the Quartus II software.