- Ethernet Blaster Communications Cable User Guide

1–12 Altera Corporation
EthernetBlaster Communications Cable User Guide December 2004
Cable Setup
Figure 1–8. EthernetBlaster Change Settings Page
3. Click Apply. The EthernetBlaster communications cable
automatically restarts. When the status LED returns to a steady
green state, the EthernetBlaster communications cable has
successfully restarted and can now be added to the Quartus II
software. See “Setting Up the EthernetBlaster Hardware in the
Quartus II Software” on page 1–13.
Configuring the EthernetBlaster Hardware to Use Dynamic IP
Addressing
To configure the EthernetBlaster communications cable to use dynamic
IP addressing, follow the directions below:
1 Depending on your connection mode, this section assumes that
you have completed the steps in “Remote Connection via
Network Using Default Factory Settings” on page 1–5, or
“Direct Connection to a Computer Using Default Factory
Settings” on page 1–8.
1. Open the EthernetBlaster Status page.