User's Manual

Automatic Reconnections

Each time you power on the Scanner, it will automatically try to

connect to the last device it was connected to.

• Make sure the device is in range with Bluetooth On.

• If using Basic Mode (HID), pressing the trigger button will force or

trigger the connection.

• If using Application Mode (SPP), make sure the Scanner-enabled

Application is active.

• If using Application Mode (SPP), make sure SocketScan 10 software

or an

application developed with SocketScan 10 SDK is running.

Make sure the device is on and in range. While the Scanner is

attempting to connect the Blue LED will blink every second.

• If a connection is made, the Blue LED will blink every 3 seconds.

• If a connection is not made after 30 attempts, the Scanner will emit

a long beep.

BLUETOOTH CONNECTION