User's Manual
Connect Apple iOS device in MFi Mode
Please check with your scanner application vendor or visit
www.socketmobile.com/appstore to conrm your Scanner-enabled
application supports the Scanner.
If you are using the Scanner with an Apple iOS device and a
Scanner-enabled Application that does not provide instructions how to
connect with the Scanner, please use the following steps.
1. Power on the Scanner. Make sure the Scanner is discoverable
(unpaired).
2. To change the prole to MFi mode scan this barcode. The Scanner will
beep 3 times.
Use with iPad, iPod touch, and iPhones.
3. Turn on Bluetooth on the Apple device. Go to Settings > Bluetooth.
A Bluetooth Devices search will begin.
4. Tap Socket Scanner[xxxxxx] in the list of Devices found. After a
few seconds the “Not Paired” status will change to “Connected”
or “Paired” and the Scanner Blue LED will blink every 3 seconds
conrming the connection.
22
APPLICATION MODE (MFI-SPP)