Owners manual

APPLICATION MODE

Connect to Android Device:

Scanner-enabled app software installation is required.

1. Power on the scanner and scan barcode below. The scanner will beep

3 times. Make sure the scanner is discoverable (unpaired). The blue

light will blink fast.

(Print page to scan. Do not scan on screen.)

(Scanning this barcode changes the connection mode)

2. Turn your device’s Bluetooth on. Go to Settings > Bluetooth. A

Bluetooth Devices search will begin.

3. Select Socket D700[xxxxxx] in the list of Devices found.

4. When prompted, tap “Pair”. After a few seconds the “Not Paired” sta-

tus will change to “Paired”.

Note: The characters in brackets are the last six characters of the scan-

ner’s Bluetooth Address.

(Continue instructions on page 17)