User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
STEP 4: Start SocketScan and Connect to CRS
1. If you did not install Connect!Agent start your computer’s Bluetooth
software and make sure the Bluetooth radio is turned on.
2. Right-click the SocketScan icon at the bottom of the screen and click
Connect CS.
If you installed Connect!Agent, it will automatically open the Bluetooth
software and turn on the Bluetooth radio when you click Connect CS.
After the correct Bluetooth hardware settings are configured in
SocketScan (either manually or by Connect!Agent), the Connect CS
menu option allows you to connect to the CRS directly from SocketScan,
instead of manually connecting via your Bluetooth software.
The Connect CS option will not appear unless you checked the box
Enable CS Support in the SocketScanXP settings.
SocketScan will not be able to connect to the CRS if you have another
device assigned as your favorite or default Bluetooth serial device.
3. If you are using Connect!Agent, and this is your first time connecting,
Connect!Agent will automatically begin searching for the CRS. After it
finds the CRS, it will automatically configure the connection.
4. SocketScan will connect the computer to the CRS.
CHAPTER 4: SETUP FOR WINDOWS XP 39