User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
Broadcom (Widcomm) Bluetooth Stack:
Refer to the manual for your Bluetooth hardware/software for specific
instructions. Many Bluetooth USB adapters use this stack.
1. Turn on the Bluetooth radio of your computer.
2. Turn on the Cordless Ring Scanner. Press the small power button on the
side of the wrist unit for at least 2 seconds, until you hear a beep. The
Bluetooth status LED on the wrist unit will start blinking blue.
3. Perform a Quick Connect to a Bluetooth Serial Port. Click the Bluetooth
icon in the task tray. Click Quick Connect | Bluetooth Serial Port | Find
Devices.
It is essential to connect to the CRS via Quick Connect because this sets
the CRS as your default Bluetooth serial device.
4. During the device search, the CRS will appear as Socket CRS [xxxxxx]
The characters in brackets are the last 6 characters of the scanner’s
Bluetooth MAC address.
5. If a passkey is requested, enter 1234. To indicate the connection, the
CRS will beep once.
By default, the Bluetooth software will ask you for the passkey each time
you connect. To stop the automatic prompts, under Advanced
Configuration, disable the Secure Connection requirement for both the
Local Service and Client Application, then unpair the devices. Refer to
the documentation for your Bluetooth hardware/software for complete
instructions.
36