User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
Toshiba Bluetooth Stack:
These instructions are based on a Motion Computing tablet. Refer to the manual
for your Bluetooth hardware/software for specific Bluetooth usage instructions.
1. Turn on the Bluetooth radio of your computer. Tap on the Dashboard icon
on the desktop. In the dashboard, check Enable Internal Bluetooth Wireless
Radio. Tap OK.
2. Turn on the Cordless Ring Scanner. Press the small power button on the
side of the wrist unit for at least 2 seconds, until you hear a beep. The
Bluetooth status LED on the wrist unit will start blinking blue.
3. Double-tap on the Bluetooth icon at the bottom of your screen.
4. In Bluetooth Settings, tap New Connection at the bottom of the screen.
5. The Add New Connection Wizard will launch. Select Custom Mode and
tap Next. The tablet will begin searching for Bluetooth devices in range.
34