User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
Microsoft Windows XP Service Pack 2:
Refer to the documentation for your Bluetooth hardware/software for
instructions on discovering and connecting to the CRS.
1. Turn on the Cordless Ring Scanner. Press the small power button on the
side of the wrist unit for at least 2 seconds, until you hear a beep. The
Bluetooth status LED on the wrist unit will start blinking blue.
2. Turn on the Bluetooth radio of your computer.
3. Use the Add Bluetooth Device Wizard to discover and connect to the
Cordless Ring Scanner. Click on the Bluetooth icon in the task tray. In
the pop-up menu, click Add a Bluetooth Device.
4. During the device discovery, the Cordless Ring Scanner will appear as
Socket CRS [xxxxxx]
The characters in brackets are the last 6 characters of the
scanner’s Bluetooth MAC address.
5. In the passkey options screen, select the option Let me choose my own
passkey and enter a passkey of your choice.
6. To indicate the connection, the CRS will beep once.
7. In the last screen of the Add Bluetooth Device Wizard, note the COM
number of the
Outgoing COM port.
CHAPTER 4: SETUP FOR WINDOWS XP 33