User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
5. Double-click on the red ball to search for the
Cordless Ring Scanner, which will appear as
Socket CRS [xxxxxx].
The characters in brackets are the last 6 characters of the
scanner’s Bluetooth MAC address.
6. Double-click on the Socket CRS icon to begin the service
discovery. After the Serial Port Service icon is highlighted
at the top of the screen, right-click on the Serial Port
Service icon and click Connect.
7. BlueSoleil will ask whether you want to connect to the CRS
automatically when Windows applications open the serial
port. Click Yes.
8. When the devices connect, the CRS will beep once, and the
Bluetooth logo in the task tray will turn green.
9. Click Tools | Configurations | Quick Connect. Choose a COM port
assigned to SPP (Serial Port Profile) and click Assign. In the next screen,
select the CRS and click OK.
Remember which COM number you
assigned to the CRS and click OK.
32