User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
STEP 1: Install the Software
You must install SocketScan, but installing Connect!Agent is optional.
Should I install Connect!Agent?
Connect!Agent simplifies the Bluetooth setup and connection
process. Once the CRS is turned on and SocketScan is
running, Connect!Agent will automatically set up and manage
the Bluetooth connection. It runs in the background and
requires no interaction from the user. For Windows XP,
Connect!Agent is only compatible with the Socket (IVT)
BlueSoleil and Microsoft XP SP2 Bluetooth stacks.
Software installation instructions
ADVANCED USERS: Refer to the README file for CAB installation
instructions.
1. Delete any bar code scanning software already installed in your
computer, including software from other companies. Make sure the
software is closed. Click Start | Control Panel | Add or Remove Programs.
Use the utility to delete the software.
2. Insert the SocketScan installation CD into the CD drive of your
computer.
3. Use My Computer or Windows Explorer to access your CD drive.
4. In the CD contents, open the SocketScanXP folder and click on the
Setup.exe file.
CHAPTER 4: SETUP FOR WINDOWS XP 29