User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
4 | Setup for Windows XP
This chapter explains how to install and use the
Cordless Ring Scanner (CRS) with a Bluetooth
enabled desktop, notebook or tablet computer
running Windows XP or Windows XP Tablet
Edition.
Before you begin the instructions in this chapter,
make sure you have charged and installed the
battery as explained in Chapter 2, “Hardware
Preparation.”
Setup Summary
STEP 1: Install the software.
STEP 2: Configure Bluetooth settings.
STEP 3: Configure scanner settings.
STEP 4: Start SocketScan and connect to CRS.
STEP 5: Assemble and put on the CRS.
STEP 6: Scan data into your application.
OPTIONAL:
• Assign sound and prefix/suffix settings.
• Configure advanced Bluetooth settings.
• Assign a remote trigger button.
• Select symbologies.
28