User's Manual
Table Of Contents
- Copyright Notice
- _
- 1 | Introduction
- Scanner Versions
- About the Software
- About Combining Scanning with Bluetooth
- System Requirements
- Package Contents
- _
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Scanner Settings
- STEP 3: Connect CRS to Host Device with Bluetooth
- STEP 4: Assemble and Put on the CRS
- STEP 5: Scan Data into Your Application
- OPTIONAL: Select Symbologies
- OPTIONAL: Configure Prefix/Suffixes
- OPTIONAL: Configure Sound
- OPTIONAL: Run Scan Demo
- 4 | Setup for Windows XP
- _
- Setup Summary
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CRS
- STEP 5: Assemble and Put on the CRS
- STEP 6: Scan Data into Your Application
- OPTIONAL: Assign Sound and Prefix/Suffix Settings
- OPTIONAL: Configure Advanced Bluetooth Settings
- OPTIONAL: Assign a Remote Trigger Button
- OPTIONAL: Select Symbologies
- _
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- _
- Appendix E Decode Zone
- _
- Appendix F Troubleshooting
- _
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
Assembling and Putting on the CRS
You can put on the CRS either with or without the case. If you choose not to
use the case, the plastic parts of the wrist unit will be more susceptible to
abuse.
How to put on the CRS with the wrist unit case
1. Insert the wrist unit into the case, pulling the free end of the cable
through the hole in the top of the case. During insertion, you may hear a
beep and see the LED flicker because the power button was pressed,
however, the wrist unit will not turn on unless the button was pressed for
more than 2 seconds, and the LED continues to blink.
2. Connect the free end of the cable to the ring scanner.
3. Attach the finger strap to the bottom of the ring scanner.
4. Put on the wrist strap. Adjust it for a secure and comfortable fit.
5. Put the ring scanner on your index finger, adjusting the finger strap for a
secure and comfortable fit.
6. Attach the wrist unit case to the wrist strap, by pressing the Velcro together.
CHAPTER 2: HARDWARE PREPARATION 13