User's Manual

89
• EN61000-4-2 – Electromagnetic Compatibility for Industrial Process
Measurement and Control Equipment, Part 2: Electrostatic Discharge
Requirements.
• EN61000-4-3 – Electromagnetic Compatibility for Industrial Process
Measurement and Control Equipment, Part 3: Radiated Electromagnetic
Field Requirements.
LASER DEVICE:
The Socket bar code scanning product(s) described in this User Guide
contain a Symbol SE955 laser scan engine.
For the Class 1 version of this engine, the following applies:
• Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant
to Laser Notice No. 50, dated June 24, 2007.
• Complies with IEC60825-1:2001-08
• Class 1 Laser devices are not considered to be hazardous when used for
their intended purpose. The following statement is required to comply with
US and international regulations:
Caution: Use of controls, adjustments or performance of procedures
other than those specified herein may result in hazardous laser light
exposure.
A label such as the one below should appear on the end product.
Example of Class 1 Laser Warning Label
For the Class 2 version of this engine, the following applies:
• Complies with 21CFR1040.10 and 1040.11 except for deviations pursuant
to Laser Notice No. 50, dated June 24, 2007.
• Complies with IEC60825-1:2001-08
• Class 2 laser scanners use a low power, visible light diode. As with any very
bright light source, such as the sun, the user should avoid staring directly
into the light beam. Momentary exposure to a Class 2 laser is not known to
be harmful.
Caution: Use of controls, adjustments or performance of procedures
other than those specified herein may result in hazardous laser light
exposure.
A label such as the one below should appear on the end product.