User's Manual

4. SocketScan and the Bluetooth CRS are now configured as a

permanent pair. In the future, whenever you want to connect the

Bluetooth CRS to the computer, simply do the following:

• Turn on the Bluetooth radio of your computer.

• Open SocketScan. Tap Start | Programs | SocketScan

folder | SocketScan.

• Turn on the Bluetooth CRS. It will automatically try to connect

to the last computer it connected to.

Note: It may take several seconds for the Bluetooth CRS to connect to

the mobile device. The

Bluetooth CRS will try to connect every 2

seconds for a maximum of 20 attempts.

• To disconnect, simply turn off the Bluetooth CRS.

Notes:

• After you turn on the

Bluetooth CRS, it will wait 5 seconds before it

starts trying to connect. During these 5 seconds, you can change

the Bluetooth CRS to acceptor mode by scanning an Acceptor Bar

Code (see example in the section, “Using ActivePairing by

Scanning Special Bar Codes”).

• If, after 20 attempts, the Bluetooth CRS cannot connect to the

mobile device (indicated by 2 long beeps with the same tone), the

Bluetooth CRS will change to acceptor mode, with the following

Bluetooth status:

Time after 2 long beeps Bluetooth mode

0-5 minutes Discoverable and connectable

5-20 minutes Connectable

20 minutes Scanner automatically powers off