User's Manual

CHAPTER 4: SETUP FOR WINDOWS XP & WINDOWS VISTA 37
STEP 3: TURN ON THE BLUETOOTH CRS
Press and hold the small power button on the left side of the wrist unit
for at least 2 seconds, until you hear two beeps (low – high).
Notes:
• See page 10 for information on beeps and LEDs.
• If the Ring Scanner is not attached, the 2 beeps will be followed by 3 long
beeps. See page 16 for more information.
After you turn on the Bluetooth CRS, it will have the following sequence
of Bluetooth modes until it connects to a computer:
Time after turning on scanner Bluetooth mode
0-5 minutes Discoverable and connectable
5-20 minutes Connectable
20 minutes Scanner automatically powers off
STEP 4: START BLUETOOTH ON YOUR COMPUTER
Refer to your Bluetooth hardware/software documentation for
instructions.
1. If using an add-on Bluetooth card or adapter, such as the Socket
Scanning Companion USB Bluetooth adapter, plug it into your
computer.
2. Start your computer’s Bluetooth software. For some computers,
the software will automatically launch after you turn on the
Bluetooth radio.
3. Turn on the Bluetooth radio of your computer. For some
computers, the radio must be enabled through the software. Other
computers have a hardware switch.
Power button