User's Manual

4. Check the box Enable Cordless Scanner support. IMPORTANT!!!

5. Tap ok in the top right corner.

Note: If the Bluetooth radio is off, a message may report that ActivePairing

is not activated. Tap ok.

Note: After Cordless Scanner Support is enabled, the SocketScan icon will

have a blue circle.

STEP 5: TURN ON THE BLUETOOTH CRS

Press and hold the small power button on the left side of the wrist unit

until you hear 2 beeps (low – high).

Note: For more information on beeps and LEDs, see page 10.

After you turn on the Bluetooth CRS, it will have the following sequence

of Bluetooth modes until it connects to a computer:

Time after turning on scanner Bluetooth mode

0-5 minutes Discoverable and connectable

5-20 minutes Connectable

20 minutes Scanner automatically powers off

Power button