User's Manual

CHAPTER 2: HARDWARE PREPARATION 13
ASSEMBLING AND PUTTING ON THE BLUETOOTH CRS
STEP 1:
Attach finger
strap to ring
unit.
Insert clip post into slot and gently push down. Repeat on other side.
Important! Do not twist the clips during insertion or removal!
Note: To remove, grasp a clip and gently pull out. Repeated removal
may distort the post and make it unusable.
STEP 2: Put on
wrist strap.
The wrist strap can be worn on the right or left wrist. Adjust for a
comfortable fit.
Note: A shorter, 6-inch strap is also available, SKU#.
STEP 3:
Connect cable
to ring unit.
Plug the narrow end of the cable into the connector on the back
of the ring unit.