User's Manual

APPENDIX F SPECIAL BUTTON SEQUENCES
R ESTORING F ACTORY D EFAULTS
To restore the CHS to its factory defaults, do the following:
1. Power on the CHS.
2. While pressing the trigger button, briefly press and release the power button.
3. After about 15 seconds, the CHS will beep. Release the trigger button. If you performed the actions
correctly, the CHS will beep 5 times and power off.
4. The next time you power on the CHS, it will take longer than normal. After the CHS finishes powering
on, it will have factory default settings (HID mode for Keyboards).
U NPAIRING THE CHS
The CHS 8Ci can be connected to only one device at a time. Disconnect before making a new connection.
To disconnect your CHS:
1. Power off - press and hold down the power button until the CHS beeps (high-low tone).
2. Power on - press and hold down the power button until the CHS beeps (low-high tone).
Your CHS is ready to reconnect.