User's Manual

Status Indicator Beeps
Beep Pattern Meaning
Low-high tone Power ON
High-low tone Power OFF
1 beep CHS connected to host device and ready to scan barcodes.
1 beep low You have double-pressed the power button and enabled support for
simultaneous scanning and onscreen keyboard entry for Apple iOS.
1 beep with green LED Data successfully scanned and sent to host device.
2 beeps, same tone CHS disconnected from host device.
1 long beep CHS unsuccessfully tried 30 times to connect to the last host device it paired
with. CHS will remain unpaired.
5 beeps CHS detects an internal fault. Power OFF to reset the error condition. If
connected to host device, scanner will disconnect during reset.
B LUETOOTH M ODE S EQUENCE
When the CHS is powered on, its Bluetooth mode will gradually change if no connection is made.
Time after turning on CHS Bluetooth mode
0-5 minutes Discoverable and connectable
5-20 minutes Connectable
20 minutes CHS automatically powers off
S IMULTANEOUS U SE OF CHS AND S OCKET M OBILE P LUG -I N D EVICE ON THE SOMO
655
You can use the CHS and a Socket Mobile plug-in barcode / RFID / magnetic stripe reader
simultaneously on a SoMo 655 handheld computer, but, you will need to run two different versions of
SocketScan concurrently.
• For the CHS, use SocketScan 10, which you can download from:
http://www.socketmobile.com/support/downloads/data-collection/series7/ss10/
• For Socket plug-in devices, use SocketScan 7 (or older), which you can download from:
http://www.socketmobile.com/support/downloads/data-collection/series5/