User's Manual
Table Of Contents
- 0BCopyright Notice
- 1B1 | Introduction
- 2B2 | Scanner Setup
- 3B3 | Setup for Windows PC
- 4B4 | Setup for Windows Mobile
- 5B5 | Setup for Apple
- 7B6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- 8BAppendix B Safety and Usage Tips
- 9BAppendix C Barcode Label Specifications
- 10BAppendix D Decode Zone
- 11B10BAppendix E Command Barcodes
- Appendix F Special Button Sequences
- Appendix G CAB Installation
- Appendix H Troubleshooting
- 12BAppendix I Technical Support
- 13BLimited Warranty
- SocketScan Software License Agreement
- 14BRegulatory Compliance
APPENDIX E: COMMAND BARCODES 91
APPENDIX E
C
OMMAND BARCODES
Scan command barcode(s) to quickly configure the CHS. By default, the CHS is in HID
mode as a Keyboard device.
IMPORTANT! Make sure the CHS is not connected to a host computer / device before
scanning a command barcode!
Bluetooth Connection Mode (General)
SPP Mode
Changes the CHS to Bluetooth Serial Port Profile (SPP) mode
(required for BlackBerry, optional for Windows and Android).
HID-Keyboard (default)
Configures the CHS as a Keyboard class device
(required for Apple iOS / Mac OS, Nokia E71).
HID-Peripheral
Configures the CHS as a Peripheral class device
(optional for Windows and Android).
iOS Mode
Changes the CHS 7Xi or 7XiRx to Apple iOS mode (equivalent to SPP mode).
Factory Defaults
Factory Reset
Configures the CHS to revert all settings to factory defaults. The CHS powers
off after scanning this barcode.
Firmware Information
Version Information (for HID mode only)
Commands the CHS to output the firmware version information into an
active application.