User's Manual

CHAPTER 1: INTRODUCTION 9
Antimicrobial Protection (CHS 7XRx and 7XiRx only)
The CHS 7XRx and 7XiRx are made with antimicrobial materials to provide an extra layer
of protection to the devices against the multiplication and spread of potentially harmful
bacteria and microbes.
Socket recommends using Sani-Cloth
®
Plus brand disposable cloth wipes as the standard
disinfectant wipe for the CHS 7XRx and 7XiRx. For more information about the wipes,
please visit: http://www.pdipdi.com
Do not use a bleach-based or Dispatch® brand cloth wipes, as they negate all
antimicrobial properties that have been added to the device.
To clean the scanner window, use an eye lens cleaner or clean, soft cloth.
Status Indicator LED
LED LED Behavior Meaning
1 blink per second Bluetooth radio is on, but not connected Bluetooth Status (Blue)
1 blink per 3 seconds Scanner connected to computer
On Data successfully scanned and transmitted to
host device
Good Read (Green)
On when connected to
charging source
Scanner is fully charged
1 blink per second 20% battery capacity remaining
On when connected to
charging source
Battery Charging (on cradle or AC power)
Battery Status (Red)
Off Powered off or Good Battery status
Status Indicator Beeps
Beep Patterns Meaning
2 beeps (low-high) Power on
2 beeps (high-low) Power off
1 beep Scanner connected to computer and ready to scan barcodes. When
connected, the scanner will auto power off after 2 hours of inactivity.
1 beep with green LED
(configurable setting)
Data successfully scanned and sent to computer.
1 beep (low) You have double-pressed the power button, and the CHS has enabled
support for simultaneous scanning and onscreen keyboard entry for
Apple iOS
2 beeps (same tone) Scanner disconnected from computer. When disconnected, the scanner
will auto power off after 5 minutes of inactivity.
1 long beep Scanner unsuccessfully tried multiple times to connect to computer. After
these attempts, the scanner will go into sleep mode. In sleep mode, if the
trigger button is pressed, the CHS will restart the connection attempts.
The CHS will automatically power off after 5 minutes of inactivity.
5 beeps The CHS detects an internal fault, will reset and power off. If connected
to a host computer, the scanner will disconnect during the reset.