User's Manual

CHAPTER 7: SETUP FOR BLACKBERRY 79
To scan barcodes:
1. Make sure the CHS is powered on, the phone has Bluetooth turned on, and
SocketScan 10 is running.
2. Open your application. Place the cursor where you want to enter data.
3. Hold the CHS about 4 inches (10 cm) from the barcode and press and hold the
trigger button. An aiming beam will appear for 3 seconds. Keep your hand
steady while scanning.
For example, try scanning the following barcode:
After data is read and sent to the phone, by default, the CHS will beep once and
vibrate, the LED will flash green, and the beam will turn off. You can use the
Scanner Settings utility (see next page) to modify the beep / LED / vibrate settings.
By default, a carriage return is applied after scanned barcode data is entered. To
disable the automatic carriage return, you can use the Scanner Settings utility (see
next page) or Command Barcodes
(use the Data Editing barcode for Data As Is).
If no data is read in a few seconds, the beam will turn off, and you must try
again.
To Disconnect:
To disconnect, turn off the CHS. Press and hold the power button for at least 3 seconds,
until the CHS beeps twice (high-low) and the blue LED turns off.
Automatic Reconnection:
After you power on the CHS, it will automatically try to connect to the last phone it
paired and connected to. Make sure your phone is in range with Bluetooth enabled.
If the CHS is connected to your phone and gets disconnected, it will try to reconnect.
Make sure the phone is on and in range. If the CHS cannot reconnect after several
attempts, it will emit a long beep. Press the trigger button to restart the reconnection
process.
See Appendix F for unpairing instructions.