User's Manual
Table Of Contents
- 0BCopyright Notice
- 1B1 | Introduction
- 2B2 | Scanner Setup
- 3B3 | Setup for Windows PC
- 4B4 | Setup for Windows Mobile
- 5B5 | Setup for Apple
- 7B6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- 8BAppendix B Safety and Usage Tips
- 9BAppendix C Barcode Label Specifications
- 10BAppendix D Decode Zone
- 11B10BAppendix E Command Barcodes
- Appendix F Special Button Sequences
- Appendix G CAB Installation
- Appendix H Troubleshooting
- 12BAppendix I Technical Support
- 13BLimited Warranty
- SocketScan Software License Agreement
- 14BRegulatory Compliance
CHAPTER 4: SETUP FOR WINDOWS MOBILE 47
7. Tap ok to exit the Scanner Settings. If desired, tap Test to test scanning a
barcode.
8. Scan a barcode that you would like information about. SocketScan will report the
barcode’s symbology, data length, and data, in your choice of ASCII text or
Hexadecimal format.
9. After testing a barcode, tap ok. Click ok to exit Scanner Settings.
After you exit Scanner Settings, the CHS will beep twice, followed by a
single beep.