User's Manual
Table Of Contents
- 0BCopyright Notice
- 1B1 | Introduction
- 2B2 | Scanner Setup
- 3B3 | Setup for Windows PC
- 4B4 | Setup for Windows Mobile
- 5B5 | Setup for Apple
- 7B6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- 8BAppendix B Safety and Usage Tips
- 9BAppendix C Barcode Label Specifications
- 10BAppendix D Decode Zone
- 11B10BAppendix E Command Barcodes
- Appendix F Special Button Sequences
- Appendix G CAB Installation
- Appendix H Troubleshooting
- 12BAppendix I Technical Support
- 13BLimited Warranty
- SocketScan Software License Agreement
- 14BRegulatory Compliance
CHAPTER 3: SETUP FOR WINDOWS PC 27
Scanner Settings
You can access Scanner Settings only when the CHS is connected to your
computer.
1. Click on the CHS icon
in the task tray. In the pop-up menu, click Scanner
settings…
2. The Scanner Settings screen will appear with an empty field. For the Microsoft
and Broadcom (Widcomm) Bluetooth stacks, the CHS will also beep twice when it
disconnects from SocketScan 10.
3. After a few seconds, the CHS will connect to Scanner Settings, indicated by a
beep. Your CHS will also be listed on the screen. Make sure your CHS is selected,
and click Properties.
4. The utility will read your scanner settings.