User's Manual

14
OPTION 1: USING THE CHS IN HID MODE
To pair the CHS with your computer:
You only need to pair the CHS with you computer the first time you try
to connect.
1. Power on the CHS. Press and hold the small power button until the LED turns
blue and the CHS beeps twice (low-high).
The LED blinks blue once per second to show that the Bluetooth radio is
on but not connected.
2. Scan this barcode to configure the CHS for HID mode for peripherals. Afterwards,
the CHS will beep 3 times.
3. Turn on Bluetooth on your computer. Refer to your computer’s documentation for
instructions.
4. Use your computer’s Bluetooth software to connect to the CHS (see
instructions on next page).
In the device search, the CHS will appear as Socket CHS 7x [xxxxxx] for the
7X / 7XRx and Socket 7Xi [xxxxxx] for the 7Xi / 7XiRx. The characters in
brackets are the last six characters of the CHS Bluetooth Device Address
(BDA), which is labeled inside the battery compartment.
To identify your type of Bluetooth stack, click Start. Right-click on My
Computer and click Properties | Hardware tab | Device Manager
and identify the manufacturer of your Bluetooth device.
Only computers running Bluetooth 2.0 will prompt for a passkey.