User's Manual

118
3. If other electrical interference or related problems occur, contact Socket technical support
at
1Uhttp://support.socketmobile.com/
Radio Frequency Interference Requirements
This device complies with part 15 of the FCC rules. Operation is subject to the following
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, meme si le brouillage est
susceptible d'en compromettre le fonctionnement."
This equipment is also ETS EN300 328-2, ETS EN301 489-1 and ETS EN301 489-17 compliant.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the interference at his or her
own expense.
This equipment generates and radiates radio-frequency energy. To comply with FCC RF
exposure compliance requirements, the following antenna installation and device operating
configurations must be satisfied: (1) Users are not permitted to make changes or modify the
system in any way, and (2) connecting external antennas to the Bluetooth Cordless Hand
Scanner is prohibited. This device and its antenna must not be co-located or operated with
any other antenna or transmitter.
To comply with Industry Canada RF exposure compliance requirements, the following antenna
installation and device operating configurations must be satisfied: The installer of this radio
equipment must ensure that the antenna is located or pointed such that it does not emit RF
field in excess of Health Canada limits for the general population; consult Safety Code 6,
available at Health Canada’s website
Uhttp://www.hc-sc.gc.ca/
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user may try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna of the radio or television.
• Increase the distance separating the equipment and the receiver.
• Connect the equipment to an outlet on a different branch circuit than that of the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
The user may find the following booklet helpful: How to Identify and Resolve Radio-TV
Interference Problems. This booklet is available from the U.S. Government Printing Office,
Washington, D.C. 20402.
Canada Certification