User's Manual
Table Of Contents
- 0BCopyright Notice
- 1B1 | Introduction
- 2B2 | Scanner Setup
- 3B3 | Setup for Windows PC
- 4B4 | Setup for Windows Mobile
- 5B5 | Setup for Apple
- 7B6 | Setup for Android
- 7 | Setup for BlackBerry
- Appendix A Specifications
- 8BAppendix B Safety and Usage Tips
- 9BAppendix C Barcode Label Specifications
- 10BAppendix D Decode Zone
- 11B10BAppendix E Command Barcodes
- Appendix F Special Button Sequences
- Appendix G CAB Installation
- Appendix H Troubleshooting
- 12BAppendix I Technical Support
- 13BLimited Warranty
- SocketScan Software License Agreement
- 14BRegulatory Compliance
APPENDIX E: COMMAND BARCODES 101
SCANNER MODES
Note: Scanning multiple commands in a single instance will overwrite (not append) the previous command.
IMPORTANT! Print out page to scan. Do not scan on screen.
Scan to Enable Description
Enabled by
Default
Scan to Disable
Factory Reset
Configures the CHS to revert all
settings to factory defaults. The CHS
wil power off after scanning this
barcode.
N/A
Continuous Scanning Mode
Makes the CHS automatically trigger
the scanning beam every few seconds.
N/A
Presentation Mode
Makes the CHS automatically activate
the scanning beam after a barcode is
detected within scanning range.
N/A
Aiming Beam
Makes an aiming beam appear when
the CHS trigger button is pressed.
Center Decoding
When enabled, the CHS reads only the
barcode that the scanner is aimed at.
Helpful for barcodes positioned close
together.
Decode 1D Barcodes Only
Disables CHS from decoding 2D
barcodes.
N/A