User's Guide
Table Of Contents
- Copyright Notice
- 1 | Introduction
- 2 | Hardware Preparation
- 3 | Setup for Windows Mobile
- 4 | Setup for Palm
- 5 | Setup for Windows XP
- STEP 1: Install the Software
- STEP 2: Configure Bluetooth Settings
- STEP 3: Configure Scanner Settings
- STEP 4: Start SocketScan and Connect to CHS
- STEP 5: Scan Data into Your Application
- Assigning Sound and Prefix/Suffix Settings
- Configuring Advanced Bluetooth Settings
- Assigning a Trigger Button
- Selecting Symbologies
- Viewing Version Information
- Appendix A Specifications
- Appendix B Safety and Usage Tips
- Appendix C Bar Code Label Specifications
- Appendix D Enabling or Disabling Symbologies
- Appendix E Decode Zone
- Appendix F Troubleshooting
- Appendix G Technical Support
- Limited Warranty
- Regulatory Compliance
VIEWING VERSION INFORMATION
1. In SocketScanXP Settings, click on the About tab.
The Trigger and Barcodes tabs will only appear if you are
connected to the CHS.
2. View the control panel applet (CPL) and CHS firmware version information.
Click OK.
To view the SocketScan software version, click on the
SocketScan icon and in the menu, click About.
CHAPTER 4: SETUP FOR WINDOWS XP 59